Hydraulic Station  » Other  »
5.0
1 votes
Are you familiar with this?
Feel free to rate it!

    • by akmal
      all reviews
      Hydraulic Station This some technical specification a bout Hydac hydraulic unit contained in NORDEX wind turbine used to give the turbine system the required pressure. This Hydac hydraulic unit with e-wiring of the heater and the thermostat on terminal box it has a flow rate Q1= 5.

      2 l/min and Q2= 24.

      6 l/min at


      1450rpm and an operating pressure P1=160 bar and P2= 150 bar also its electric data of motor 400V-50Hz,solenoid 230V-50Hz,Heater 400V-50Hz,it works in mineral hydraulic oil medium.

      It has a hydac tank breather filter, which is used in this unit to filter the air entering oil tanks .

      It must be designed on the following ...


      • specification the filtration rating of air breather filter must be smaller than the filtration ratings of the hydraulic filter.

        The Hydac station also contains a level switch to determine the oil level reaches a limit or not by opening (normally closed switch) or closing (normally opened switch this level switch.

        Also it contains

        a heating system thermostat to monitor and controlling the oil temperatures in the hydraulic station.

        Other filter is called the return line filters type this filter is designed for fitting directly onto oil tanks.

        The pressure is being controlled by FLUTEC pressure relief valves DB12; also it contains the bladder accumulators it is used for storing fluids.




    • Don't Be Nice. Be Helpful.

    The review was published as it's written by reviewer in October, 2005. The reviewer certified that no compensation was received from the reviewed item producer, trademark owner or any other institution, related with the item reviewed. The site is not responsible for the mistakes made. 12251012560431/k2311a1025/10.25.05
    Your use of this website constitutes acceptance of the Terms & Conditions
    Privacy Policy